- Go to RIOT OS website and follow the instruction in the link below : https://doc.riot-os.org/getting-started.html
make all BOARD=wyres_proto
make flash BOARD=wyres_proto
- Run ST's software : STM32CubeProgrammer
- Connect the board and choose ST-Link
- Select Hardware reset in the configuration panel
- Transfer the .elf/.bin that has been created
- Start Programming
- If your using a standalone ST-Link with the wyres and the board won't connect after you flashed it with CubeProgrammer: You want to reset (by removing the batteries e.g.) the board between your flashes
- The usage of a Discovery Board allows to reset directly without hardware manipulation
- Don't forget to remove the short-circuit module on the ST-Link Pin before flashing