TinyUSB (CDC+MSC) Keil STM32F0 Not Working

[g-Mutlu]

Hi Guys,

Used the example in the tinyusb folder for MSC. (tinyusb-master\examples\device\cdc_msc\src)
I can successfully run the same code in STM32CubeIDE. However, Keil didn't happen in Uvision5. Does not recognize the USB device. Can you help me?
Note: In STM32CubeIDE, the compiler uses GNUC.
I had to enable -gnu to compile it in keil.

Code:
STM32F0_MASS_STORAGE_V00.zip

[hathach]

have you tried to compile it with current make file. Maybe you miss some of macros, config etc with the cube IDE

[AshishvSpanidea]

Hi Guys,

Used the example in the tinyusb folder for MSC. (tinyusb-master\examples\device\cdc_msc\src) I can successfully run the same code in STM32CubeIDE. However, Keil didn't happen in Uvision5. Does not recognize the USB device. Can you help me? Note: In STM32CubeIDE, the compiler uses GNUC. I had to enable -gnu to compile it in keil.

Code: STM32F0_MASS_STORAGE_V00.zip

Hey @g-Mutlu what was the STM32 board you used. I have STM32F072 Discovery Board. I had followed both #633 and https://anvilelectronics.ovh/tinyusb-na-stm32-device-cdc/ steps to implement tinyUSB in STM32CubeIDE but it couldn't enumerate.
Any suggestions.

Regards
Ashish