-
Notifications
You must be signed in to change notification settings - Fork 0
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Wiring or schematic of the PCB #1
Comments
Hi @cparrapa, because i did not write my own software until now, i did not write the rebro completely. Sorry but i have no circuit diagram :( |
No worries are you able to run 6 servos with that without resets or browns? |
Yes with the cap it is possible, but with out boostconverter and alkaline battery (4* 1,5V) it works more stable. |
Hi what cap is that 100uF? and what happens with 1.5V if in total is 6V and the booster supposed to deliver 5V? |
The Elko is a 10V 1000uF.
It slightly reduces the voltage. At 6V I get about 5.8V |
thanks i will give a try! |
Hi @JackGruber
First great work very interesting DIY PCB, do you have the wiring?
4AA battery holder with a booster?, so how many batteries do you use? What input voltage?
2 batteries in parallel? Not sure if the red booster is able to buck down from 6volt
The text was updated successfully, but these errors were encountered: