-
Notifications
You must be signed in to change notification settings - Fork 58
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
[INFO] Some ESP32 feedback #111
Comments
I have been running this ever since on both my units. No problem at all so far with the hardware. Software I found a specific bug with my unit, but that's nothing to do with the electrical and stements above |
does it still work for you? |
@Lauriz7 yes this is still running flawlessly for me |
Thanks to this, I just got mine up and running. Works flawlessly. |
Not a bug report or an issue, just wanted to give some feedback to help the README and such alone.
I do have some minor questions/bugs but I will post those separately so they can be tracked
Thanks for making this, it works well and straight out of the box for me!
I have a model with Both CN-CNT and CN-WLAN ports. The DNSK-P11 module was already installed in the CN-WLAN port.
Since I use the CN-CNT port I needed to configure "type: cnt".
I do not have 12V at the CNT connector. (it's floating)
Since an ESP32 is completely 5V tolerant, it can just work without a level shifter (The 3.3V data from the ESP is higher to the 5V than 0V on the Airco receiver side, so that also doesn't even mind it)
I just literally connected it like this to the ESP32:
I uploaded the example code, and it just worked.
The Airco now uses 0.25W more with the ESP32. The Airco + WiFi was 0.65W, and now with the ESP32 included its about 0.9W. It is of course possible to remove the WiFi module to have a lower Idle load again.
The text was updated successfully, but these errors were encountered: